This is a discussion on Oil Pressure Pole. within the General Maintenance, Troubleshooting & Accidents. forums, part of the Tech & Modifying & General Repairs category; Weight fore teh pole. Just curious....
Weight fore teh pole.
Just curious.
Last edited by wrx wagone; 10-09-2009 at 04:57 PM.
This message printed on 100% recycled electrons.
Moderator for: Aftermarket Vendor & Installer Review / Detailing Forum / Engine Modifications / Exterior & Appearance
New Member Hangout / Off Topic / Tri-State
ScoobyDMC #003 Blobeye Syndicate #10
2004 WRX Sedan PSM 5MT Tactrix Stage 2+ Blouch TD04 19T @ 21 psi
Mods & Pics
Moderator for: Aftermarket Vendor & Installer Review / Detailing Forum / Engine Modifications / Exterior & Appearance
New Member Hangout / Off Topic / Tri-State
ScoobyDMC #003 Blobeye Syndicate #10
2004 WRX Sedan PSM 5MT Tactrix Stage 2+ Blouch TD04 19T @ 21 psi
Mods & Pics
No option for huge pole?
I has teh huge pole![]()
"Never Launched"![]()
Dougie - Founder, 250,000 mile club
-5,000 posts
^^ Just because your wife tells you that doesn't mean squat.![]()
Paul
2007 MS3
Maintenance schedule and poke in the eyes:
http://www.clubwrx.net/forums/genera...nce-guide.html
20-24 psi for me during idle. Reading off oil plug below my alternator.
Not sure about the acuracy of prosport though.
What weight oil are you 20-24 psi crew running?
This message printed on 100% recycled electrons.
I am running the prosport gauge. Last motor was reading around 16-18ish then dropped to 0-5ish right after I pulled into a parking lot. Never had my dummy light come on and the oil was full. I have to get the sender off the old motor and get installed before it gets too cold out.
Blobeye Syndicate #26
'05 2.0l WRX, 245awhp, 243awtq. Cobb Stage 2
Bookmarks