Lots of Blow By & Blowing smoke
Results 1 to 3 of 3

This is a discussion on Lots of Blow By & Blowing smoke within the General Maintenance, Troubleshooting & Accidents. forums, part of the Tech & Modifying & General Repairs category; Hey guys hoping sum1 can help me out, new to the wrx. Having troubles with lots of blow by going ...

  1. #1
    Registered User
    Join Date
    Sep 2009
    Posts
    2

    Exclamation Lots of Blow By & Blowing smoke

    Hey guys hoping sum1 can help me out, new to the wrx.

    Having troubles with lots of blow by going into the top mount and leaking out the front of the turbo where the intake pipe connects to it, also when the oil filler cap is removed on idle it blows smoke from it almost smells and looks like exhaust fumes shooting out??? i have no idea what is happening had sum1 say could be rings and pistons? doesnt blow much smoke out the exhaust mayb a little white smoke on first start up. Also when the engine is cold it takes usually round 10 seconds of cranking to kick over and start, but when warm it starts straight up no worries??? im hoping this isnt going to cost me too much!!!! mods that have been done - link engine management computer, malpasi fuel reg, no afm cos of the computer, thats it stock other then that and runs 14-15 pound no troubles.

    Any suggestions ideas really appreciated guys!!


    Just ran a compression test and have 120 on 1,3 and 4 cylinders and 60-70 on the 2nd cylinder

    obviously this is not good! rings-pistons??
    but why isnt the car blowing any smoke from the exhaust?? only blows smoke out of the oil filler cap when its takin off and car is idleing?
    Last edited by r1ch1e_11; 10-05-2009 at 01:26 AM.

  2. Remove Advertisements
    ClubWRX.net
    Advertisements
     

  3. #2
    Banned
    Join Date
    Dec 2003
    Location
    Dallas, TX / Sterling, VA
    Posts
    6,629
    I Support ClubWRX
    Time for a compression test.

  4. #3
    Registered User
    Join Date
    Sep 2009
    Posts
    2
    does any1 know if its a straight drop in for a ej207 sti motor??

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •