header rattle
Results 1 to 2 of 2

This is a discussion on header rattle within the General Maintenance, Troubleshooting & Accidents. forums, part of the Tech & Modifying & General Repairs category; alright on the lower side of the header right in the center where the left and right sides connect normally ...

  1. #1
    Registered User gogetr's Avatar
    Join Date
    Dec 2007
    Posts
    39

    header rattle

    alright on the lower side of the header right in the center where the left and right sides connect normally there would be a bracket of sorts pulling the two ends together or they are welded. mine... is not. i dont know if there was a bracket there and it just decided to relocate its self some where on the road or what. i watched it slide in and out(not completely, but a good 1" or better) of its self. i only noticed that one spot where they connect, is there another? i was in a bit of a rush when i looked. and would it be alright to weld it together or should i tac a couple things to each side and attach something to pull them together?

    im worried about doing to much welding down there do to the oil pan and everything else.

  2. Remove Advertisements
    ClubWRX.net
    Advertisements
     

  3. #2
    Registered User gogetr's Avatar
    Join Date
    Dec 2007
    Posts
    39
    anyone?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •