HKS blow-off Valve Problem. need help
+ Reply to Thread
Results 1 to 3 of 3

This is a discussion on HKS blow-off Valve Problem. need help within the Engine Modifications forums, part of the Tech & Modifying & General Repairs category; I'm having problems with my my car because of the HKS-BOV. I recently installed my HKS-BOV bout a month ago, ...

  1. #1
    Leo
    Leo is offline
    Registered User Leo's Avatar
    Join Date
    Feb 2004
    Location
    Nu-JerZey
    Posts
    40

    HKS blow-off Valve Problem. need help

    I'm having problems with my my car because of the HKS-BOV.
    I recently installed my HKS-BOV bout a month ago, My car bogs out on me. Everytime I switch gear to neutral to slow down my RPM jumps all the way down to 0 and then jumps back up again to regain power. Sometime when I slow down on the highway and then switch from a gear to nuetral, the car dies on me, I usually have to restart the car while the car is still moving on the highway, It just scares me sometimes. What can I do to my BOV to avoid this problem? thanks
    Last edited by Leo; 02-02-2004 at 12:28 AM.

  2. Remove Advertisements
    ClubWRX.net
    Advertisements
     

  3. #2
    Registered User KanosWRX's Avatar
    Join Date
    Dec 2001
    Location
    Northern VA
    Posts
    3,975
    Is the spring to loose and causing air to vent all the time? do you have any problems keeping full boost? I would also try sticking your stock one back on just to see if its actually the BOV that is causing the problems, maybe you knocked something when you installed it. I have an HKS, haven't had it long, but I have had no issues with it.


    My Mods


    "The most important mod is the one behind the steering wheel" - Koyokid RIP

  4. #3
    Leo
    Leo is offline
    Registered User Leo's Avatar
    Join Date
    Feb 2004
    Location
    Nu-JerZey
    Posts
    40

    Is the spring to loose and causing air to vent all the time? do you have any problems

    I put the stock BOV back in the car it was fine, when I put it back in it stated doing it again. I think I have to adjust the screw on the BOV to adjust the pressure but I'm not sure which way I should twist it.

+ Reply to Thread

Quick Reply Quick Reply

Register Now

Please enter the name by which you would like to log-in and be known on this site.
If you do not want to register, fill this field only and the name will be used as user name for your post.

Please enter a password for your user account. Note that passwords are case-sensitive.

Please enter a valid email address for yourself. We strongly suggest that you stay away from using aol, yahoo, msn, and hotmail accounts. Sometimes the mail server blocks the emails from our server. As a result you will not receive any notifications including the confirmation email.

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.


Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
  •