Alright what should I do about a log?
This is a discussion on Little or no boost :/ within the Engine Modifications forums, part of the Tech & Modifying & General Repairs category; Alright what should I do about a log?...
What would I need to log it/ do learning view?
2015 CWP WRX STi ... But how did I get roped back into an EJ motor?!
Zax's utterly unimaginably stock 2015 STi build thread
Zax's Shaggin' Wagon Build Thread Now tuned for 99% pure Unicorn Jizz!
Zach | Moderator | Builds, Electronics/Car Audio, Engine Modifications, Mid-Atlantic States, Suspension & Wheels, Tech & Modifying & General Repairs |
Rollin' with the Bugeye Mafia #302
Facebook me here
Your Mid-A local board: http://www.clubwrx.net/forums/mid-atlantic-states/
I always forget what works for other years, so you should double check, but I think this is all you need. If you get the block you should be able to reflash with it too. You may be able to just pull a log with a vagcom cable which is a lot cheaper.
EvoScan: OpenPort 1.3U interface cable for Mitsubishi and Subaru Drive-by-Wire, EvoScan, TAC-OpenPort1.3U
Vag-Com cable resource thread - NASIOC
"From a little spark may burst a mighty flame." - Dante
"The stitch is lost unless the thread is knotted." - Italian proverb
I also read that the bcs should click a time or two when you turn the key on. Any truth to this?
This one works for me:
but by now I'm tired of recommending it to every other person on club WRX because i seem to be doing so every other post...
David - '05 WRX
Ok thanks would be much easier since I have an amazon account versus eBay.
Just got my vag com cable in today so hopefully I'll be able to do learning view.