Help with new head unit
Results 1 to 2 of 2

This is a discussion on Help with new head unit within the Electronics/Car Audio forums, part of the Interior Mods category; So today I had a buddy of mine install a new head unit. It works fine and functions properly. However, ...

  1. #1
    Registered User
    Join Date
    Feb 2011
    Location
    Pittsburgh PA
    Posts
    34

    Help with new head unit

    So today I had a buddy of mine install a new head unit. It works fine and functions properly. However, every time I turn the car off the unit is reset. So basically it reverts back to the out of the box setup. Does anyone know what could cause this issue? Also the head unit is a Pioneer 50wx4 MOSFET. Not sure if that matters but any help would be appreciated.

  2. Remove Advertisements
    ClubWRX.net
    Advertisements
     

  3. #2
    Supporting Member mjboudreaux77's Avatar
    Join Date
    Sep 2007
    Location
    Northern Vermont
    Posts
    843
    I Support ClubWRX
    Somewhere you hooked the power supply to the switched 12V supply. That line isn't mean to support a lot of current draw, so you need to pull the unit back out and check all connections again.

    I assume you used a wiring harness that came with instructions? If so, it should only take a while to go through and check all the colors match.
    If I don't die by Thursday, I'll be roarin Friday night - Jimmy Buffett

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •