This is a discussion on Ermahgerd! Ruh Roh's burgeye burld threard within the Builds forums, part of the Tech & Modifying & General Repairs category; Originally Posted by Mikie13 Give me that exhaust. Give me back that filet o' fish...
2015 CWP WRX STi ... But how did I get roped back into an EJ motor?!
Zax's utterly unimaginably stock 2015 STi build thread
Zax's Shaggin' Wagon Build Thread Now tuned for 99% pure Unicorn Jizz!
Zach | Moderator | Builds, Electronics/Car Audio, Engine Modifications, Mid-Atlantic States, Suspension & Wheels, Tech & Modifying & General Repairs |
Rollin' with the Bugeye Mafia #302
Facebook me here
Your Mid-A local board: http://www.clubwrx.net/forums/mid-atlantic-states/
he has stock for 75$ but did not, i know he does get discount from places. i think he orders from jscspeed and they dont have any instock. if i were to order id go through boston motorsport for $270 and get it next day. but im not sure its the rad thats leaking. ill know tonight and prob order something tonight if it is leaking. ill 99% get the mishimoto rather than stock
Yea I def could've,..should've. Seems simple. The thing I don't like about the kit is where the serial male and female cables plug together they don't include screws to hold them together. It's a pretty secure connection but I'd like some screws lol
Sent from my iPhone using Tapatalk
But anyway for an update. All "exhaust shops" were closed or didnt weld exhausts...my dads friend who welds my stuff his welder is broke til next weekend. So downpipe wideband sensor and heat wrap has been postponed. Spark plugs Ngk iridium stock heat levels are in and wasn't hard or bad at all. I'd say putting my battery tie downs in the stupid holes was the hardest part... Also a bolt kinda started to want to cross thread but took my time retightning it and it was fine. The cool packs closest to the fire wall suck I take out because they hit the body and barely enough room to wiggle them out.
As for the "radiator leak" it turned out it wasn't my rad leaking. Small cut in upper rad hose. Replaced. Water wetter added. Runs a little below middle of hot and cold.
Tmmrw I will hopefully be painting front prodrive lip but not installing yet and painting eyelids with white plastidip then silver paint on top.
Sent from my iPhone using Tapatalk
update- painted on some eyelids with like 5 coats of white plastidip, then about 4 coats of the grimmspeed PSM paint. used plastidip just so i can peel it off if i didnt like it and didnt want paint right on my headlights. i also painted my prodrive front lip PSM. hoping to get my wb02 welded and DP heatwrapped ths week. still waiting on the EBCS setup in the mail and my s204 lip
bung welded in DP, DP heat wrapped, AEM UEGO in. front lip should be here today, install tmmrw. I believe all the definitions for ECUflash, Romraider defintions and logger have been installed. ecuflash is downloaded to my mac, while romraider is on my moms netbook. Will be downloading the disc for my USB to serial cable for logging the wideband. By this weekend hoping to uninstall my AP and save stock ROM, see if wideband is logging properly and do like 2 logs then reinstall AP until i set a date for tune and then ill set up the EBCS
Who's doing your AP tune? Just curious as I'll probably be picking one up soon.
also for note of install i used an add a line fuse on the radio acc fuse 9 for power to the gauge and the ground i used was on bolt under the dash behind the hood latch. will most likely be using both those points for next gauge as well.