Also, today I installed a trailer hitch and have it mostly wired! I noticed an improvement in the rear end of the car with the stock suspension, since i actually installed ie prior to the GC/Koni stuff.
The wiring is the same as the thread on Scoobymods.com
http://www.scoobymods.com/forums/sho...=trailer+hitch
Quote:
|
Originally Posted by Scooby Mods
WRX ONLY - without the six-pin connector, you will need to splice into the car's factory wiring harness for the trailer hitch harness. The following are the wire color and the function for each wire you will need to splice into. Be sure to check each wire for proper function before splicing though.
a. White w/ red stripe - Taillights
b. Black w/ green stripe - Left turn signal
c. Lt. Green w/ black stripe - Right turn signal
d. White w/ black stripe - Brake lights
e. Blue w/ red stripe - Battery (wagon, unknown in sedan)
|
Other than the wiring it was a simple job. I was lucky enough to bust a nut off in the frame rail... but it wasn't going to be reused anyway! I also found that the rear bumper should be cut a little bit in one place but I'll address that later. Pics to come soon!